Start a new topic

Shorted Heater Wires - now printer down, beeping from piwer supply

I accidentally shorted one of the heater wires to the chassis as I was troubleshooting the latest problem with my Creatr. Sparks flew.

Now the printer will not connect and there is constant beeping from the power supply (the beeping stops if I pull the 4-pin PS connector on the main board.

Anyone know what may have been damaged and how to correct it?


I can replace any of the PCB components if needed if they can be identified!

Thanks!


Login or Signup to post a comment

Filament Guide

ABS
  • Extrude at ~ 225o C.
  • Requires heated bed.
  • Works reasonably well without cooling.
  • Adheres best to polyimide tape.
  • Filament tolerances are usually tighter.
  • Prone to cracking, delamination, and wraping.
  • More flexible.
  • Can be bonded using adhesives or solvents(Acetone or MEK).
  • Fumes are unpleasent in enclosed areas.
  • Oil Based.
PLA
  • Extrude at ~ 180-225o C.
  • Benefits from heated bed.
  • Benefits greatly from cooling while printing.
  • Adheres well to a variety of surfaces.
  • Finer feature detail possible on a well calibrated machine.
  • Prone to curling of corners and overhangs.
  • More brittle.
  • Can be bonded using adhesives.
  • More pleasant smell when extruded.
  • Plant Based.

Demo Print Downloads

Drivers Downloads

Software Downloads

Firmware Downloads

Please request a firmware download via the Ticket System

Filament Video Library