Start a new topic

The printing stops before finishing the piece

When the printer is printing and it takes a while , suddenly , not just for the part. Also for software , that is, while Repetier for the machine .

I do not know if the fault is leadfrog or computer.
I need help

when the PC goes in sleep mode or hybernation all stops.. deactivate all screensavers and powersaver settings

In the lower part of the window in Repetier Host there is a log window.
Check the messages in that window to see if there is an error being reported when this happens.
Try turning off "Infos" so that there are fewer messages in the window. Otherwise it might scroll off the top of the screen and get missed.

 

Login or Signup to post a comment

Filament Guide

ABS
  • Extrude at ~ 225o C.
  • Requires heated bed.
  • Works reasonably well without cooling.
  • Adheres best to polyimide tape.
  • Filament tolerances are usually tighter.
  • Prone to cracking, delamination, and wraping.
  • More flexible.
  • Can be bonded using adhesives or solvents(Acetone or MEK).
  • Fumes are unpleasent in enclosed areas.
  • Oil Based.
PLA
  • Extrude at ~ 180-225o C.
  • Benefits from heated bed.
  • Benefits greatly from cooling while printing.
  • Adheres well to a variety of surfaces.
  • Finer feature detail possible on a well calibrated machine.
  • Prone to curling of corners and overhangs.
  • More brittle.
  • Can be bonded using adhesives.
  • More pleasant smell when extruded.
  • Plant Based.

Demo Print Downloads

Drivers Downloads

Software Downloads

Firmware Downloads

Please request a firmware download via the Ticket System

Filament Video Library