Start a new topic

Transparent hybrid filament

Does anyone know what material this hybrid is? 

what temp settings should I use? I use ABS settings, works more or less OK.. but I would like more info..

1 Comment

Below is what has worked for me.


Layerheight (mm) 0.2

Speed (mm/s) 50 (you can increase speed this is just what I tested at)

Temperature (C) 240-245

Build Plate Temperature (C) 60-70


Layerheight (mm) 0.1

Speed (mm/s) 50 (you can increase speed this is just what I tested at)

Temperature (C) 235-240

Build Plate Temperature (C) 60-70



Login or Signup to post a comment

Filament Guide

ABS
  • Extrude at ~ 225o C.
  • Requires heated bed.
  • Works reasonably well without cooling.
  • Adheres best to polyimide tape.
  • Filament tolerances are usually tighter.
  • Prone to cracking, delamination, and wraping.
  • More flexible.
  • Can be bonded using adhesives or solvents(Acetone or MEK).
  • Fumes are unpleasent in enclosed areas.
  • Oil Based.
PLA
  • Extrude at ~ 180-225o C.
  • Benefits from heated bed.
  • Benefits greatly from cooling while printing.
  • Adheres well to a variety of surfaces.
  • Finer feature detail possible on a well calibrated machine.
  • Prone to curling of corners and overhangs.
  • More brittle.
  • Can be bonded using adhesives.
  • More pleasant smell when extruded.
  • Plant Based.

Demo Print Downloads

Drivers Downloads

Software Downloads

Firmware Downloads

Please request a firmware download via the Ticket System

Filament Video Library