Start a new topic

Stops printing mid print

the Printer stops printing prematurely. the part isn't finished but the print bed is lowered. as it is a 9 hour print and was done over night i can't say anything about what happend. furthermore i printed two other parts using the same gcode. any suggestions    

Look motor of filament, we have strange problem with one, it is blocked.

Hennag Hansen did you figure this out?


Hello Hennag, i can probably say that the extruder got blocked or the filament was entangled on the spool and the machine stoped extruding at some point.

Login or Signup to post a comment

Filament Guide

  • Extrude at ~ 225o C.
  • Requires heated bed.
  • Works reasonably well without cooling.
  • Adheres best to polyimide tape.
  • Filament tolerances are usually tighter.
  • Prone to cracking, delamination, and wraping.
  • More flexible.
  • Can be bonded using adhesives or solvents(Acetone or MEK).
  • Fumes are unpleasent in enclosed areas.
  • Oil Based.
  • Extrude at ~ 180-225o C.
  • Benefits from heated bed.
  • Benefits greatly from cooling while printing.
  • Adheres well to a variety of surfaces.
  • Finer feature detail possible on a well calibrated machine.
  • Prone to curling of corners and overhangs.
  • More brittle.
  • Can be bonded using adhesives.
  • More pleasant smell when extruded.
  • Plant Based.

Demo Print Downloads

Drivers Downloads

Software Downloads

Firmware Downloads

Please request a firmware download via the Ticket System

Filament Video Library