Just got my Creatr HS and I'm sad to say that i'm not happy with the print quality so far.
It seems no matter what I do, the corers of print comes out crappy, the printer seems to extrude of filament when it is doing the corners.
This part is printed in Maxx PLA, with the setting recommended by Lpfrg them self:
The prints is made in 0.2 mm layer thickness, with support according to the pre-set settings. The support is not easy to remove.
Any one have any ideas on how to resolve this?
I can compare this with our old Printrbot that we build our self 3 years ago, this printer produces way better prints than the HS :-(.
So far not happy..........
When you have backlash on either X and/or Y axes, the extrusion tends to group in pair of lines, so that 2 lines are closer, then a gap, and another 2 lines, a.s.o. This is visible on top and bottom layers (or any other 100% infilled layer). And so was in your pictures :)
All The Best,
Are you aware that your top/bottom infill exhibits an artifact (extrusion lines groups of two) that indicates a backlash on X/Y axis/es? It might be due to the short driving belts being loose.
All The Best,
Just thought I'd upload 2 photos for a simple test / calibration block to check how my printer is performing especially for quality and accuracy.
You can see by the corners that they come up nice and sharp.
I originally used the Leapfrog .fff files as a basis for printing then tweaked them as needed.
One thing I do remember is that I think the default print speed is far too high, the print speed for these test blocks is about 2000M/min.
I've tried printing at the HS default high speeds and unless the part is very basic in shape you tend to sacrifice quality for speed hence my speed is much lower but the speed and corner are really good..
Hope this proves of interest to you or anyone else having the same problem.
Sorry to see that you were having a frustrating start to using your HS.. I had a lot of problems at the start and in the end Leapfrog replaced my machine.
Since this post is quite old I wondered if you resolved you problem....? I would be interested to know.
As Robert said they pretty bad and I had some challenges at the start 'tweaking / tuning' my process settings to suit the particular print I was doing but got there in the end.
If you are still having problems with a particular print maybe I could try a comparison test on my HS and see what I results I can reproduce....
Let me know if this is interest and let's see what we can do..... and if I don't hear back from you then happy printing and I hope it is all going well.
The whole part looks bad, not just the corners.
I don't have an HS but sure it can do better.
The extrusion width appears irregular and there are a lot of gaps which might have to do with the retraction settings or something else.
Even though you are using the official HS settings, you probably need to go through some calibration steps. Different filament can make a huge difference and you can't be sure that Maxx was even used to develop the settings. (They might have come from Simplify 3D.)
The first thing I would do is take a magic marker and put two marks on your filament 100mm apart. Then manually extrude 100mm to make sure that 100mm is actually being extruded. If not, the filament may be slipping in the extruder. (I don't know how to adjust that on the HS.)
Then I would start by printing a simple calibration cube Then you can start adjusting the temperature, flow rates, and retraction to get the best results.
That sucks... You should probably lower your extruder temperature if it is oozing on the corners. I like 190 - 200 anything above that is usually too hot for PLA. Are you using PVA support structure or use same material support? Have you tried changing the resolution of the support pillars. If your temperature is in that range I suggested then you might try increasing your retraction.
Please request a firmware download via the Ticket System