Start a new topic

Extruder Not Heating

I just clean nozzle of extruder and when i fix it back the temperature stop raising.


i verified the heaters its fine but still when i put heater back to the printer it will not work.


Please some one advise me on this issue 


My whats-app number is +966597733640 please send me your suggestion.



1 Comment

Dear asim ali,


Is the thermistor connector tightly in its place? As well, is your software reading the room temperature or is it showing 0 C; do you see in the "Communication" tab any M999 error; when heating the extruder, does the led from the electronic board corresponding to the E0/E1 (whichever you have the problem with) thermistor mosfet light up?

Login or Signup to post a comment

Filament Guide

ABS
  • Extrude at ~ 225o C.
  • Requires heated bed.
  • Works reasonably well without cooling.
  • Adheres best to polyimide tape.
  • Filament tolerances are usually tighter.
  • Prone to cracking, delamination, and wraping.
  • More flexible.
  • Can be bonded using adhesives or solvents(Acetone or MEK).
  • Fumes are unpleasent in enclosed areas.
  • Oil Based.
PLA
  • Extrude at ~ 180-225o C.
  • Benefits from heated bed.
  • Benefits greatly from cooling while printing.
  • Adheres well to a variety of surfaces.
  • Finer feature detail possible on a well calibrated machine.
  • Prone to curling of corners and overhangs.
  • More brittle.
  • Can be bonded using adhesives.
  • More pleasant smell when extruded.
  • Plant Based.

Demo Print Downloads

Drivers Downloads

Software Downloads

Firmware Downloads

Please request a firmware download via the Ticket System

Filament Video Library