Start a new topic

CreatrHS sounds in pain

I'm new to 3D printing, but my CreatrHS sounds like it might need some oil somewhere, or is this normal?


About 10 small prints since I unpacked it.




Hi,

I have the same noise on mine, I find that this is in the y movement. When I inspect the printer I found one screw on the right panel that is loosened. I tighten it and the noise disappear.

Perhaps it is the same thing for you ?


G*

 

   The noise is coming from the bearings that are moving on the Y axis. This is happening because of the motor moves and you can adjust the noise by anointing with grease and decreasing the print speed. Also, you can print still, because it will not affect the print or the printer itself.  

Login or Signup to post a comment

Filament Guide

ABS
  • Extrude at ~ 225o C.
  • Requires heated bed.
  • Works reasonably well without cooling.
  • Adheres best to polyimide tape.
  • Filament tolerances are usually tighter.
  • Prone to cracking, delamination, and wraping.
  • More flexible.
  • Can be bonded using adhesives or solvents(Acetone or MEK).
  • Fumes are unpleasent in enclosed areas.
  • Oil Based.
PLA
  • Extrude at ~ 180-225o C.
  • Benefits from heated bed.
  • Benefits greatly from cooling while printing.
  • Adheres well to a variety of surfaces.
  • Finer feature detail possible on a well calibrated machine.
  • Prone to curling of corners and overhangs.
  • More brittle.
  • Can be bonded using adhesives.
  • More pleasant smell when extruded.
  • Plant Based.

Demo Print Downloads

Drivers Downloads

Software Downloads

Firmware Downloads

Please request a firmware download via the Ticket System

Filament Video Library