Start a new topic

PID tuning.Creatr HS

When downloaded, PID tuning file appears as a *.stl file on the computer, but then copied on flash drive and put into Creatr HS cannot be found by the printer. 



Just change the extension from stl to gcode and should work.

Dear Valerii Demianchuk,


In regards to your PID question at this point I would suggest you do a full software and firmware update for your HS printer. You can find the links explaining how to do this below:


1. Update CreatrHS Stand-Alone software


2. Flash new firmware on the CreatrHS

Once the software and firmware are done you need to remember to input the offsets for the hot ends:

3. Set extruder offset for your CreatrHS (M50)


Let me know if this improves the quality of your prints.

Login or Signup to post a comment

Filament Guide

ABS
  • Extrude at ~ 225o C.
  • Requires heated bed.
  • Works reasonably well without cooling.
  • Adheres best to polyimide tape.
  • Filament tolerances are usually tighter.
  • Prone to cracking, delamination, and wraping.
  • More flexible.
  • Can be bonded using adhesives or solvents(Acetone or MEK).
  • Fumes are unpleasent in enclosed areas.
  • Oil Based.
PLA
  • Extrude at ~ 180-225o C.
  • Benefits from heated bed.
  • Benefits greatly from cooling while printing.
  • Adheres well to a variety of surfaces.
  • Finer feature detail possible on a well calibrated machine.
  • Prone to curling of corners and overhangs.
  • More brittle.
  • Can be bonded using adhesives.
  • More pleasant smell when extruded.
  • Plant Based.

Demo Print Downloads

Drivers Downloads

Software Downloads

Firmware Downloads

Please request a firmware download via the Ticket System

Filament Video Library