Start a new topic

Review about defective product

Last year (2014) febrary I acquired a model Creatr. First with I confronted with what is scored extruder. It has been in use. After the statement you sent the new extruder. Secondly I found that scored one tube with filament completly. I don't send about with and clean personaly. After about three months of work, there was a failure. Improperly executed movement. I went to the company that delivered the printer. The problem  be rectified, By personal reasons I until May to 2015 with the printer was not working. After working a little time old problems emerged, I personally started to research and found four separated wires inside the wire bundle. It is obvious that in such a printer on sale. The company SmartPrint  has just twisted them again. I personaly repare with, Finaly аfter two hours to the work it is completely stopped and no longer works.It is clear that the problem is serious. I'm totally frustrated in the product. Serial  C-1099-2448, my name Andri, Ucraine,

Login or Signup to post a comment

Filament Guide

ABS
  • Extrude at ~ 225o C.
  • Requires heated bed.
  • Works reasonably well without cooling.
  • Adheres best to polyimide tape.
  • Filament tolerances are usually tighter.
  • Prone to cracking, delamination, and wraping.
  • More flexible.
  • Can be bonded using adhesives or solvents(Acetone or MEK).
  • Fumes are unpleasent in enclosed areas.
  • Oil Based.
PLA
  • Extrude at ~ 180-225o C.
  • Benefits from heated bed.
  • Benefits greatly from cooling while printing.
  • Adheres well to a variety of surfaces.
  • Finer feature detail possible on a well calibrated machine.
  • Prone to curling of corners and overhangs.
  • More brittle.
  • Can be bonded using adhesives.
  • More pleasant smell when extruded.
  • Plant Based.

Demo Print Downloads

Drivers Downloads

Software Downloads

Firmware Downloads

Please request a firmware download via the Ticket System

Filament Video Library