Start a new topic

Pausing print

When pausing in the middle of a print for a jam or change filament color after purging the filament through the nozzle when you resume printing the software retracts the filament by the same amount that you have extruded it by. This is great for say returning the z height back to the pre-paused height to resume printing but is a pain when the filament gets retracted as well as this leads to an air print. Anybody else have the same problem? Using simplify 3d 3.0.2

1 Comment

Are you using the latest software and firmware available for the Creatr HS printer?

1. Update CreatrHS Stand-Alone software


2. Flash new firmware on the CreatrHS


3. Set extruder offset for your CreatrHS (M50)


Please install the latest software and firmware in this order and see if the issue is still present.

Login or Signup to post a comment

Filament Guide

ABS
  • Extrude at ~ 225o C.
  • Requires heated bed.
  • Works reasonably well without cooling.
  • Adheres best to polyimide tape.
  • Filament tolerances are usually tighter.
  • Prone to cracking, delamination, and wraping.
  • More flexible.
  • Can be bonded using adhesives or solvents(Acetone or MEK).
  • Fumes are unpleasent in enclosed areas.
  • Oil Based.
PLA
  • Extrude at ~ 180-225o C.
  • Benefits from heated bed.
  • Benefits greatly from cooling while printing.
  • Adheres well to a variety of surfaces.
  • Finer feature detail possible on a well calibrated machine.
  • Prone to curling of corners and overhangs.
  • More brittle.
  • Can be bonded using adhesives.
  • More pleasant smell when extruded.
  • Plant Based.

Demo Print Downloads

Drivers Downloads

Software Downloads

Firmware Downloads

Please request a firmware download via the Ticket System

Filament Video Library