Start a new topic

the piece is printed out climbing about 4 mm approximately

hello we have several XL leapfrog the piece that scale printing and can not find the solution.

I've tried everything, changing motherboard, change engines, adjust straps ....

there are times that prints well but 1 in 10 or 20, almost always goes scaling

thank you 

1 Comment

Are you saying that the models you are printing are not turning out at the correct size? Could you maybe provide some pictures of the models. On which axis is the model not accurate? X Y or Z?

Do you have a Creatr XL or a Creatr HS XL?

Login or Signup to post a comment

Filament Guide

  • Extrude at ~ 225o C.
  • Requires heated bed.
  • Works reasonably well without cooling.
  • Adheres best to polyimide tape.
  • Filament tolerances are usually tighter.
  • Prone to cracking, delamination, and wraping.
  • More flexible.
  • Can be bonded using adhesives or solvents(Acetone or MEK).
  • Fumes are unpleasent in enclosed areas.
  • Oil Based.
  • Extrude at ~ 180-225o C.
  • Benefits from heated bed.
  • Benefits greatly from cooling while printing.
  • Adheres well to a variety of surfaces.
  • Finer feature detail possible on a well calibrated machine.
  • Prone to curling of corners and overhangs.
  • More brittle.
  • Can be bonded using adhesives.
  • More pleasant smell when extruded.
  • Plant Based.

Demo Print Downloads

Drivers Downloads

Software Downloads

Firmware Downloads

Please request a firmware download via the Ticket System

Filament Video Library