Start a new topic

Model drifting X-Y on Creatr Dual

I've been having this drifting issue with certain larger models, I recently ran into the same issue with a small and simple one, so I figured it's a simpler question to disect: If I print one copy of the bushing it prints out straight. If I print two side by side, they drift in the X-Y plane, see pictures. Using simplify3d. It's thin and printed solid by setting the outer shells to 10 to avoid any infill. Your thoughts would be greatly appreciated.
Login or Signup to post a comment

Filament Guide

ABS
  • Extrude at ~ 225o C.
  • Requires heated bed.
  • Works reasonably well without cooling.
  • Adheres best to polyimide tape.
  • Filament tolerances are usually tighter.
  • Prone to cracking, delamination, and wraping.
  • More flexible.
  • Can be bonded using adhesives or solvents(Acetone or MEK).
  • Fumes are unpleasent in enclosed areas.
  • Oil Based.
PLA
  • Extrude at ~ 180-225o C.
  • Benefits from heated bed.
  • Benefits greatly from cooling while printing.
  • Adheres well to a variety of surfaces.
  • Finer feature detail possible on a well calibrated machine.
  • Prone to curling of corners and overhangs.
  • More brittle.
  • Can be bonded using adhesives.
  • More pleasant smell when extruded.
  • Plant Based.

Demo Print Downloads

Drivers Downloads

Software Downloads

Firmware Downloads

Please request a firmware download via the Ticket System

Filament Video Library