Start a new topic

Control Bolt from Simplify3D

Is it possible to use Simplify3D's machine control panel to control the Bolt?, If so, how?, I'm trying to keep the bed on between prints, it takes too long to heat up. Thanks
1 Comment

There is no way to control the printer using Simplify 3D. There is no way to establish a connection between the printer and a PC using Simplify 3D.

The only connection which can be established is by mirroring the user interface with the IP address generated by the printer when connected to a network.

Login or Signup to post a comment

Filament Guide

  • Extrude at ~ 225o C.
  • Requires heated bed.
  • Works reasonably well without cooling.
  • Adheres best to polyimide tape.
  • Filament tolerances are usually tighter.
  • Prone to cracking, delamination, and wraping.
  • More flexible.
  • Can be bonded using adhesives or solvents(Acetone or MEK).
  • Fumes are unpleasent in enclosed areas.
  • Oil Based.
  • Extrude at ~ 180-225o C.
  • Benefits from heated bed.
  • Benefits greatly from cooling while printing.
  • Adheres well to a variety of surfaces.
  • Finer feature detail possible on a well calibrated machine.
  • Prone to curling of corners and overhangs.
  • More brittle.
  • Can be bonded using adhesives.
  • More pleasant smell when extruded.
  • Plant Based.

Demo Print Downloads

Drivers Downloads

Software Downloads

Firmware Downloads

Please request a firmware download via the Ticket System

Filament Video Library